Quick answer: No. Attachments, retained material and operating geometry consume part of the strip length.
Can cut length be treated as usable travel?
The manufacturing dimension controls material input, while the product requires a functional window. Both belong in design review. A change to an end tab may preserve cut length yet reduce motion. Keep dimensional and assembled functional acceptance separate.
A practical verification method
Check cut length and verify usable motion in the designated assembly independently.
| Item | What to record | Purpose |
|---|---|---|
| Reference configuration | Part or assembly identity and drawing revision | Make comparisons traceable |
| Test conditions | Relevant position, direction and operating condition | Compare the same characteristic |
| Decision evidence | Check cut length and verify usable motion in the designated assembly independently. | Resolve the specific question before approval |
Use the result in an engineering request
Describe the observed condition and the required function separately. Include the relevant drawing revision and your results from the check above. If an acceptance limit has not been established, identify it as an open design input rather than treating a successful trial as approval.
Review the related Leading Spring product information. For a project-specific review, send the mechanism description, available geometry and the evidence relevant to this decision through the contact page.
Editorial note: AI-assisted engineering guidance, prepared from the topic-specific reasoning shown here and the company’s public product context. Illustrations explain decisions; they are not customer-case photographs or test results. Product-specific suitability requires review against your approved requirements.