Quick answer: State the held position, environment and dwell duration, then record first restart and the subsequent force profile.
What should be recorded during a dwell evaluation?
The product may spend most of its life at one extension. A rapid continuous cycle test does not describe that use. An observed change can arise from contacts or assembly settling as well as the strip itself, so preserve diagnostic comparisons.
A practical verification method
Measure before dwell, immediately after restart and after repeated motion at identical reference positions.
| Item | What to record | Purpose |
|---|---|---|
| Reference configuration | Part or assembly identity and drawing revision | Make comparisons traceable |
| Test conditions | Relevant position, direction and operating condition | Compare the same characteristic |
| Decision evidence | Measure before dwell, immediately after restart and after repeated motion at identical reference positions. | Resolve the specific question before approval |
Use the result in an engineering request
Describe the observed condition and the required function separately. Include the relevant drawing revision and your results from the check above. If an acceptance limit has not been established, identify it as an open design input rather than treating a successful trial as approval.
Review the related Leading Spring product information. For a project-specific review, send the mechanism description, available geometry and the evidence relevant to this decision through the contact page.
Editorial note: AI-assisted engineering guidance, prepared from the topic-specific reasoning shown here and the company’s public product context. Illustrations explain decisions; they are not customer-case photographs or test results. Product-specific suitability requires review against your approved requirements.